19.10.2015, 22:29
Amiblitz3 IDE (PED or AIDE) makes only sense on 3.9 or higher (MOS/OS4 ok) with high end machine > 128MB, 60MHz, 1200x800x256, 68020/FPU.
Amiblitz3 executables *technically* use FPU only if you use "optimize 2" to switch from softfloats to hardware floats, or a BlitzLib that uses FPU like FPULib (obviously).
99% of the BLitzLibs don't use FPU. However, Bernd managed to sneak in some FPU instructions in various very central places, so right now all AB3 exectuables will require FPU.
If we can track it down of Bernd would help us, it would be good to remove this dependency, but it is not high-pri since AB3 targets mainly high end machines.
Amiblitz3 executables *technically* use FPU only if you use "optimize 2" to switch from softfloats to hardware floats, or a BlitzLib that uses FPU like FPULib (obviously).
99% of the BLitzLibs don't use FPU. However, Bernd managed to sneak in some FPU instructions in various very central places, so right now all AB3 exectuables will require FPU.
If we can track it down of Bernd would help us, it would be good to remove this dependency, but it is not high-pri since AB3 targets mainly high end machines.